12.3 Blind Spot Detection Control Module/Module 2 -J1086-/-J1087-, Removing And Installing

Special Tools And Workshop Equipment Required 

• Torque Screwdriver - VAG1624-

Removing 

• Disconnect the connector -4-.
• Remove the upper bolt -2-.
• Remove the Blind Spot Detection Control Module - J1086-/Blind Spot Detection Control Module 2 - J1087- from the bracket -3-.

Remove The Bracket: 

• Remove the lower bolt -2-.
• Remove the bracket -3-.

Installing 

Install in the reverse order of removal while noting the following:

The blind spot detection calibration normally occurs automatically.

Static calibration is only required when there is a DTC memory entry.

Tightening Specifications 

• Refer to 12.1 Overview - Blind Spot Detection