11.7.2 Peripheral Camera System, Calibrating

• The vehicle must be on a level surface.
  NOTE: The vehicle in the illustration is only a basic outline.
• Roll out the -VAS721001- at the left and right near the vehicle.
  • The arrows -1- on the calibration patterns point in the vehicle direction of travel.
• Install the rear and front clamping strip on the calibration patterns of the -VAS721001-.
• Align the crosshairs -2- to the front axle of the vehicle (center front wheel).
• Align both calibration patterns parallel. The vehicle must be located in the center between both calibration patterns.

Pay attention to the following measurement requirements:

• Dimension -a- 2000 to 2500 mm ± 5 mm, front and rear the same
• Dimension -b- (distance from front wheel contact surface to the calibration pattern) must be even on both sides.
• Dimension -c- (distance from rear wheel contact surface to the calibration pattern) must be even on both sides.
  • Set-up the requirement for the vehicle. Refer to .
  • Connect the Vehicle Diagnostic Tester.
  • Perform the calibration using the Vehicle Diagnostic Tester.