Basic Height Adjustment
Special tools and workshop equipment required
- Hex Ball Socket: T10058
Screw -2- can be adjusted by a total of 16 revolutions, screw -5- by 11 revolutions. The center position is the base setting.
One turn = 1 mm adjustment.
Right turn = door window up, left turn = door window down.
New window regulators are delivered with the correct basic setting.
-- Move the door window -1- all the way downward toward the basic setting.
-- Remove the caps -7- on the underside of the door.
The : T10058 -4- can be used to turn the adjusting screw.
The tool -4- is inserted on the front window regulator rail at an angle of 23° -a- to approximately 102 mm -c-.
The tool -4- is inserted on the rear window regulator rail at an angle of 10° -b- to approximately 103 mm -d-.
-- Turn the front and rear adjusting screws -2- all the way down.
-- Rotate the front adjusting screw -2- exactly eight turns upward.
-- Rotate the rear adjusting screw -2- exactly five and a half turns upward.
The center position is now reached. The basic adjustment is completed.