Control Module for Emergency Call Module and Communication Unit -J949-, REPLACING

Control Module for Emergency Call Module and Communication Unit -J949-, Replacing and Adapting

• Current data for the "Guided Fault Finding" 

-- Select the Replace control module  function on the Vehicle Diagnostic Tester in the Guided Fault Finding  or Guided Functions  mode for the Control Module for Emergency Call Module and Communication Unit -J949-.

-- Remove the Control Module for Emergency Call Module and Communication Unit -J949-. Refer to Control Module for Emergency Call Module and Communication Unit -J949-, REMOVING AND INSTALLING .

-- Install the new Control Module for Emergency Call Module and Communication Unit -J949-. Refer to Control Module for Emergency Call Module and Communication Unit -J949-, REMOVING AND INSTALLING .

-- Select the Coding  function on the Vehicle Diagnostic Tester in the Guided Fault Finding  or Guided Functions  mode for the Control Module for Emergency Call Module and Communication Unit -J949-.

-- Select the Adapting to Immobilizer  function on the Vehicle Diagnostic Tester in the Guided Fault Finding  or Guided Functions  mode for the Control Module for Emergency Call Module and Communication Unit -J949-.

-- Select the Activating  function on the Vehicle Diagnostic Tester in the Guided Fault Finding  or Guided Functions  mode for the Control Module for Emergency Call Module and Communication Unit -J949-.

-- Excluding PR number NZ3: exit Guided Fault Finding  or Guided Functions  .

-- Only for PR number NZ3: in Guided Fault Finding  or Guided Functions  , select the function "ERA Glonass, Operating" in the Vehicle Diagnostic Tester.

-- Switch off the ignition.