Selector Shaft Seal, Replacing

Special tools and workshop equipment required 

• Seal Installer - Selector Shaft Oil Seal: T10174 
• Puller - Crankshaft/Power Steering Seal: T20143/1 

-- Remove the Multifunction Transmission Range Switch -F125-. Refer to MULTIFUNCTION TRANSMISSION RANGE SWITCH, REMOVING AND INSTALLING .

-- Carefully remove the selector shaft seal with the : T20143/1  . Do not to damage the selector shaft while doing so.

-- Coat the outer edge and sealing lips of the seal with ATF.

• Installed position: open side of the seal faces the transmission housing.

-- Use the : T10174  to install the new seal until it stops. Do not tilt the seal while doing so.

Fig 1: Identifying New Gasket Driven In Until Stop Using Thrust Piece T10174

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Multifunction Transmission Range Switch -F125-, Installing. Refer to Multifunction Transmission Range Switch -F125-, Installing .