Front Sensor, Removing and Installing: Removing
- Remove the front section of the front wheel housing liner. Refer to Wheel Housing Liner; Front Wheel Housing Liner, Removing and Installing.
- Press both locking tabs in the direction of the -arrow A- and, at the same time, push the sensor -1- inward from the outside. -->
- Release and disconnect the connector -2-.
Install in reverse order of removal and note the following:
CAUTION: An incorrect or damaged decoupling ring can lead to malfunctions.
Do not stretch the decoupling ring.
Replace any damaged decoupling rings and make sure the correct decoupling ring is installed. - Check the sensor -1- decoupling ring -3- for damage and replace it, if necessary.
NOTE:
Both sensor mount retaining brackets must engage audibly when installing the sensor.