Right Engine Mount, Removing And Installing: Removing

WARNING: This page is about a different car, the 2014 Audi A8 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Several of the following work procedures are shown on opposite side of the vehicle.

-- Support the engine in its installed position, refer to ENGINE, SUPPORTING IN INSTALLED POSITION .

-- Remove the front section -1- of the right front wheel housing liner, refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING .

Fig 1: Left Front Wheel Housing Liner

Courtesy of AUDI OF AMERICA, LLC

-- Remove the generator, refer to GENERATOR, REMOVING AND INSTALLING .

Vehicles with version 1 of Electrohydraulic Engine Mount Solenoid Valve:

Fig 2: Identifying Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -2- from the Right Electrohydraulic Engine Mount Solenoid Valve -N145-.

-- Remove the bolts -1- and -arrows- and move the retaining plate to the side.

Vehicles with version 2 of Electrohydraulic Engine Mount Solenoid Valve:

Fig 3: Installed Location For Electrohydraulic Engine Mount Solenoid Valve

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -3- from the Right Electrohydraulic Engine Mount Solenoid Valve -N145-.

-- Remove the bolts -2-.

NOTE: Ignore -item 1-.

-- Remove the bolts -1 and 2- and move the retaining plate to the side.

Fig 4: Identifying Bolts

Courtesy of AUDI OF AMERICA, LLC

All vehicles:

-- Remove the engine mount.