There Are Two Choices for Calibrating/Adjusting:
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
The "Quick Access"
This procedure should be selected for the following activities if only the calibration/adjustment will be performed.
- "No or incorrect basic setting/adaptation" is stored actively in the Diagnostic Trouble Code (DTC) memory.
- The camera was removed or replaced,
- The bumper or the radiator grille was removed or replaced,
The "Complete Alignment"
This procedure should be selected for the following activities if a calibration/adjustment and a suspension adjustment will be performed.
- Adjustments were made on the rear axle,
- Parts of the suspension were replaced on the vehicle.
NOTE:
Both procedures are programmed into the axle alignment computer. The respective procedure is performed automatically. It is only necessary to select the appropriate program for the procedure that will be performed.
Refer to Preparation Work for Calibrating and Adjusting Driver Assist Systems. .