Vehicle Electrical System Control Module -J519-, REPLACING

The work procedure "replace the vehicle electrical system control module" contains the following scope of work: 

• If a new Vehicle Electrical System Control Module -J519- is installed, it must be coded online.
• The factory mode in the Vehicle Electrical System Control Module -J519- is deactivated.
• All of the remote keys are programmed again.

The procedure to "replace the vehicle electrical system control module" can only be performed with the Vehicle Diagnostic Tester in the "Guided Fault Finding"  function.

Procedure 

-- Replace the Vehicle Electrical System Control Module -J519- using the Vehicle Diagnostic Tester in Guided Fault Finding  , Replace vehicle electrical system control module  .