April 5, 2026: LEMON Manuals is launched! Read the announcement.

Bevel Box, Removing

Special tools and workshop equipment required

Socket And Extended Bit: T10107A
Used Oil Collection and Extraction Unit: SMN372500
Hex Ball Socket: 3247
Torque Wrench 1331 5-50Nm: VAG1331
Grease for Clutch Plate Shaft Splines. Refer to Parts Information.

CAUTION:

This procedure contains mandatory replaceable parts. Refer to component overview prior to starting procedure.

Mandatory Replacement Parts

Bolt - Flange
Bolts - Bevel Box to Transmission

Removing

-- Remove the subframe without the steering gear. Refer to SUBFRAME WITHOUT STEERING GEAR, REMOVING AND INSTALLING .

-- Remove the catalytic converter and front exhaust pipe. Refer to CATALYTIC CONVERTER, REMOVING AND INSTALLING .

-- Remove the right drive axle. Refer to DRIVE AXLE, REMOVING AND INSTALLING .

-- Remove the bolts -A and B- from the bevel box and remove the heat shield -1-.

GWWN39-10761

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove bolts -1 and 2- and bevel box transmission support.

Fig 1: Tightening Sequence for Bevel Box Bracket (Vehicles with TFSI Engine)

GWWA34-11216

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolt for the right flange shaft using the : T10107A .

Fig 2: Removing The Countersunk Bolt Using T10107A

GWWN34-11121

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Insert two bolts in the flange and counterhold the flange shaft with the tire iron.

Fig 3: Identifying Right Flange Shaft Countersunk Bolt, Socket And Key T10107

GWWA34-0615

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bevel box bolts -arrows- on the transmission.

Fig 4: Bevel Box Mounting Bolt Location

GWWA39-10189

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove bevel box from transmission together with flange shaft toward the right.

-- Install the bevel box. Refer to BEVEL BOX, INSTALLING .