Front Axle Differential Lock, Installing
Install in the reverse order of removal while noting the following:
-- Push the engine/transmission toward the front (a second technician is needed).
-- Slide the front axle differential lock completely onto the transmission. While doing this, join the flange shaft/front axle differential lock centrally with the differential. If necessary, turn on the flange shaft.
-- With the correct tooth position and central guiding, the front axle differential lock slides all the way up against the transmission.
-- Install any cable ties that were loosened or cut off during removal at their same location.
Do not pull the front axle differential lock with the bolts against the transmission, otherwise the front axle differential lock will tilt and the mounting eyes could break.
-- Screw in the lower bolts -arrows- for the front axle differential lock and tighten them. Tightening specification: -item ) OVERVIEW - FRONT AXLE DIFFERENTIAL LOCK - List Item: Bolt.
-- Screw in the upper bolts -arrows- for the front axle differential lock and tighten them. Tightening specification: -item ) OVERVIEW - FRONT AXLE DIFFERENTIAL LOCK - List Item: Bolt.
-- Tighten the flange shaft with a countersunk bolt. Tightening specification: -item ) OVERVIEW - FRONT AXLE DIFFERENTIAL LOCK - List Item: Bolt.
-- Install the new bolts -1- for the pendulum support on the transmission. Refer to OVERVIEW - SUBFRAME MOUNT .
-- Install the connector -arrow- on the Differential Locks Control Module -J647-.
-- Install the right drive axle. Refer to DRIVE AXLE, REMOVING AND INSTALLING .
-- If equipped, install the drive axle heat shield -arrows-. Refer to DRIVE AXLE HEAT SHIELD, REMOVING AND INSTALLING .
-- Fill the front axle differential lock. Refer to FRONT AXLE DIFFERENTIAL LOCK FLUID, DRAINING AND FILLING .
-- Assemble the exhaust system. Refer to OVERVIEW - MUFFLER .
-- Install the noise insulation. Refer to OVERVIEW - NOISE INSULATION .