Overview - SUBFRAME Mount
WARNING: This page is about a different variant/trim than selected.
- Bolt
- Tightening specification and sequence. Refer to Fig 2.
- Always replace
- Engine Support
- Removing and installing. Refer to ENGINE SUPPORT, REMOVING AND INSTALLING .
- Engine Mount
- With support arm
- Removing and installing. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
- Bolt
- 40 Nm +90°
- Always replace
- Bolt
- 20 Nm +90°
- Always replace
- Bolt
- 40 Nm +90°
- Always replace
- Bolt
- 60 Nm +90°
- Always replace
- Pendulum Support
- Removing and installing. Refer to PENDULUM SUPPORT, REMOVING AND INSTALLING .
- Bolt
- Tightening specification and sequence. Refer to PENDULUM SUPPORT, REMOVING AND INSTALLING .
- Always replace
- Bolt
- Tightening specification and sequence. Refer to PENDULUM SUPPORT, REMOVING AND INSTALLING .
- Always replace
- Bolt
- Tightening specification and sequence. Refer to PENDULUM SUPPORT, REMOVING AND INSTALLING .
- Always replace
- Bolt
- 60 Nm +90°
- Always replace
- Bolt
- 60 Nm +90°
- Always replace
- Transmission Mount
- With support arm
- Removing and installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING .
- Bolt
- 50 Nm + 90°
- Always replace