11.2 Peripheral Camera Control Module - J928-, Removing And Installing
NOTE:
If the Peripheral Camera Control Module - J928- is replaced, call up the respective function using the Vehicle Diagnostic Tester.
Removing
- Raise the front seat into its highest position and then move it all the way back.
- Turn off the ignition and all electrical equipment.
- Move the ignition key outside of the vehicle to prevent switching on the ignition unintentionally.
- Remove the expanding rivets -arrows-.
- Push the cover -1- with the Peripheral Camera Control Module - J928-, straight in the direction of travel, while paying attention to the connected wires and turn.
- Release and disconnect the connectors -3-.
- Release the catches on the cover -1- in the direction of the -arrow-.
- At the same time remove the Peripheral Camera Control Module - J928- -2- from the cover -1-.
Installing
Install in reverse order of removal and note the following:
- Calibrate the peripheral camera. Refer to 11.7 Peripheral Camera, Calibrating