Coding II table
WARNING: This page is about a different car, the 2006 Audi A4, 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
| Empty characters | 00 | |||||
| Country/emissions | 16 | ULEV (emissions regulation) | ||||
| Drive/auxiliary functions | 0 | Front Wheel Drive without TCS/ESP | ||||
| 2 | All Wheel Drive without traction control system | |||||
| 5 | Front-wheel drive with TCS/ESP | |||||
| 7 | All Wheel Drive with traction control system | |||||
| Transmission | 0 | 5-Speed Manual Transmission | ||||
| 1 | 6-Speed Manual Transmission | |||||
| 5 | Automatic Transmission 01V | |||||
| 8 | Multitronic 01J | |||||
| Model | 1 | Audi A4 |
- Confirm entry with -Q- button.
Display on VAS 5051:
1 - Coding II being carried out
- Wait until next display appears.
Fig 2: Diagnostic System VAS 5051: Display - (Coding Of Vehicle System Performed & Control Module Identification With New Coding)
Display on VAS 5051:
1 - Coding II being carried out in vehicle system
2 - Control module identification with new code
(previous code in brackets)
- Exit function "07 - Encode Engine Control Module" by pressing the ← button.
- Switch ignition off and then switch on again after 15 seconds.
NOTE:
- The next time the ignition is switched on the newly entered code will be activated.
- If the ignition is not switched off and on after the correct code has been entered, it will not be possible to erase DTC "01044 Control module incorrectly coded").