Control Position, Reprogramming Using Vehicle Diagnostic Tester

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Vehicle Diagnostic Tester with Corresponding Diagnostic Cable

WARNING:

During a test drive, the testing and measuring equipment must always be secured on the back seat.
These devices may be operated only by a passenger during a test drive.

-- Connect the Vehicle Diagnostic Tester to the vehicle using the appropriate diagnostic cable.

-- Switch on the Vehicle Diagnostic Tester.

The Vehicle Diagnostic Tester is ready to operate when it displays operating modes in button fields.

-- Turn on the ignition.

Requirements

The vehicle must be standing on an even surface.
The vehicle may not be loaded.
The Electronic Damping Control Module -J250- must be coded.
The DTC memory may not contain any vehicle level sensor DTC memory entries.

NOTE:

If control modules or electric/electronic components were replaced, then the components must be adapted under "Guided Functions".

-- Touch Guided Functions and the screen.

Then:

-- Select the corresponding program in "Guided Functions".

-- Follow the prompts on the screen.

NOTE:

If the control position was programmed again on vehicles with lane assist, the Directional Stabilization Assistance Control Module -J759- with integrated camera must be calibrated, refer to CALIBRATION PROCEDURE .