Engine Control Module: Installing
WARNING: This page is about a different car, the 2012 Audi Q5, 2011 Audi Q5, 2010 Audi Q5, and 2009 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal.
-- After that, the ECM -- must be equipped with the metal retainer.
-- Clean threaded holes for shear bolts of locking compound residue. Cleaning can be performed with a thread cutter (tap).
-- Always use new shear bolts.
- Tightening Specifications E-box cover bolts: 3.5 Nm
Perform the following step after installing a new engine control module:
-- Activate the engine control module in the "Guided Functions " operating mode under "Replace engine control module " on the vehicle diagnosis and service system VAS5051B.