Navigation System with CD Drive Control Module -J401-, REMOVING AND INSTALLING, MMI, THROUGH 11/03/2008: Removing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Open the left storage compartment in the luggage compartment.

-- Loosen the nuts -1-, -2-, -4- and -5- on the infotainment rack -3-.

Fig 1: Identifying Nuts On Infotainment Rack

Courtesy of AUDI OF AMERICA, LLC

-- Tilt the rack -3- into the luggage compartment until the connectors on the Navigation System with CD Drive Control Module -J401- are accessible.

-- Disconnect the connector from the MOST bus.

-- Insert the Fiber-Optic Repair Set - Connector Protective Caps VAS6223/9 -1- onto the MOST bus connector -2-.

Fig 2: Fiber-Optic Cable Harness Connector And Protective Cap For Cable Connector VAS 6223/9

Courtesy of AUDI OF AMERICA, LLC

-- Release and disconnect the remaining connectors from the Navigation System with CD Drive Control Module -J401-.

-- Insert two clips from the Radio Removal Tool T10057 into release slots on Navigation System with CD Drive Control Module -J401- until they engage. Points on the grip eyelets of tool face outward.

Fig 3: Inserting Radio Release Tool T10057 Clips Into Slots Of Navigation System With CD Drive Control Module J401 Until They Engage

Courtesy of AUDI OF AMERICA, LLC

-- Pull Navigation System with CD Drive Control Module -J401- out of the rack.

-- Remove Radio Removal Tool T10057 by pressing locking tabs on Navigation System with CD Drive Control Module -J401-.