Fuel Additive For FSI Engines, Adding

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2015 Audi S8, 2015 Audi A8 Quattro, 2014 Audi S8, 2014 Audi A8 Quattro, and 2013 Audi S8. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Applies to certain countries only. Refer to the Maintenance table.

-- Add Fuel Injector Cleaner G17 depending on the measured value for the regular fuel tank. Refer to READING MEASURED VALUE BLOCK 32 .

Add Fuel Injector Cleaner G17 into the fuel tank in a ratio of 10 ml of additive for every 10 liters of fuel.
The following table shows the required quantities for each fuel level shown in the fuel gauge.

Mixture Ratio:

Fuel gauge	G17 additive
Approximately 1/4	Approximately 23 ml
Approximately 1/2	Approximately 45 ml
Approximately 3/4	Approximately 68 ml
Approximately 1/1	Approximately 90 ml

NOTE:

The values in the table are based on a 90 liter fuel tank.

If there are other fuel capacities in the fuel tank which are not mentioned in the table, then add 10 ml of additive for every 10 liters of fuel.

If values 2 and 4 in measured values block 32 deviate (Refer to READING MEASURED VALUE BLOCK 32 .) then increase the amount of Fuel Injector Cleaner G17 by factor 4. Example: fuel gauge at 1/4, approximately 90 ml of fuel additive G17.

WARNING: If the repeated measured value in measured values block 32 then a repair is necessary. Refer to ENGINES CTUB - FUEL INJECTORS , ENGINES CEUA, CGTA, CTFA & CTGA - FUEL INJECTORS , ENGINES CDRA - FUEL INJECTORS or ENGINES CEJA & CTNA - FUEL INJECTORS, REMOVING AND INSTALLING .