Power Steering Gear, Removing And Installing, RHD: Installing

WARNING: This page is about a different car, the 2017 Volkswagen Touareg, 2016 Volkswagen Touareg, and 2015 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal while noting the following:

-- Bleed steering system. Refer to POWER STEERING SYSTEM, BLEEDING .

-- Check the steering system for leaks. Refer to STEERING SYSTEM, CHECKING FOR LEAKS .

-- Check the hydraulic fluid level and fill if necessary. Refer to POWER STEERING, CHECKING FLUID LEVEL .

-- Install wheels and tighten. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .

-- After installation, a vehicle alignment must be performed. Refer to WHEEL ALIGNMENT .

-- Perform basic setting for Steering Angle Sensor -G85-.

Use the Vehicle Diagnostic Tester.

Body

Electrical System

01_OBD-capable systems

16 Steering column electronics control module J527

16 Steering column electronics control module functions

16 Steering column electronics control module basic setting

Follow the instructions on the screen to perform the basic setting.

Tightening Specification

Component	Tightening specification
Pressure-/return line to steering gear	32 Nm
Clamps to steering gear	9 Nm
Universal joint to steering gear Use new bolt.	20 Nm + 90°
Heat shield to steering gear	9 Nm
Tie rod to steering knuckle Use new nut.	90 Nm
Steering gear to subframe Always use new nuts and bolts.	90 Nm + 90°
Front final drive to subframe Always use new nuts and bolts.	90 Nm + 90°
Subframe to body Use new bolts.	120 Nm +180°