LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Volkswagen >> 2017 >> e-Golf SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 1453 (Wiring) >> 97 Wiring >> Control Modules >> Rear Seat Heating Control Module -J786- >> Rear Seat Heating Control Module -J786-, Removing And Installing >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Rear Seat Heating Control Module -J786-, Removing And Installing: Notes

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

The Rear Seat Heating Control Module -J786- is located under the instrument panel to the left of the glove compartment.

-- Switch off the ignition and all electrical consumers and remove the ignition key.

-- Remove the glove compartment. Refer to STORAGE COMPARTMENTS, COVERS AND TRIM .

-- Disconnect the connector -arrows- and pry off the bracket -1- for the control module -2- and buzzer -3-.

Fig 1: Identifying Connector -Arrows-, Bracket -1- For Control Module -2- And Buzzer -3-
GWWN97-12124Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
NOTE:

It is not possible to remove the bracket for the control module without damaging it. Always replace the bracket after removing it.

-- Remove the control module from the bracket.