Operation 4: Adapting kick down functionl

WARNING: This page is about a different car, the 2006 Audi A4, 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

1) Only on vehicles with automatic transmission.

Test conditions

Engine stopped, ignition switched on

Fig 1: Diagnostic System VAS 5051: Display

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Display on VAS5051:

1 - Enter display group

Enter "063" for "display group number 063" in zone -2- and confirm entry by pressing -Q- button.

Fig 2: Diagnostic System VAS 5051: Display - Display Fields

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Display on VAS5051:

Activate basic setting by pressing -A- button.

NOTE: You will now be instructed to: "Operate kick down".

Fully depress accelerator pedal beyond kickdown point and keep it pressed.

NOTE: During the kickdown point adaptation process, "Kickdown ADP running" is shown on the display. After successful adaptation of the kickdown point "Kickdown ADP OK" appears on the display.

Check indication in display field -4-.

	Display zones
	1	2	3	4
Display group 063: Adapting kickdown function
Display	xx%	xx%	Kick down	---
Display	Sensor 1 for Accelerator pedal position	Adapted kick down value sensor 1 for accelerator pedal position.	Kick down	Adaptation status
Range			Kick down	Starting ADP process running ADP OK ERROR
Specif. value	79 to 94%	79 to 94%	Kick down	ADP OK
				If "ERROR" is displayed: Interrogate fault memory. Refer to Diagnostic Trouble Code (DTC) memory, checking .

Note on display zone 4:

If "ERROR" can be displayed, if e.g. accelerator pedal is not pressed when instructed by tester, or if accelerator pedal was released while adaptation was already running but process was not yet complete. In both cases it is necessary to exit the "Basic setting" mode and restart the adaptation process.

If specification "ADP OK" is obtained:

Press ← button.
Perform next operation.