Third Row Seat: Removal
WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
Short wheel base shown, long wheel base similar.
- Position the liftgate opening weatherstrip aside.
- Release the clips and the liftgate scuff plate trim panel.
- Remove the load floor cover.
- Position the load floor storage compartment cover up.
- Remove the vehicle jack assembly.
- Disconnect the keyless entry rear antenna electrical connector.
- Remove the load floor storage compartment bolts.
- Release the clips and remove the load floor storage compartment.
- Disconnect the third row center seatbelt from the third row center seatbelt retractor mini-buckle.
- Press the release button.
- Release the third row center seatbelt.
Third row double seat
- Remove the third row double seat front bolts.
- Remove the bolt covers.
- Remove the bolts.
Torque: 35 lb.ft (47 Nm)
-
- Pull up the elastic strap.
- Feed the third row center seatbelt retractor mini-buckle into the seat cushion pocket.
- Feed the third row double seat outer seatbelt buckle into the seat cushion pocket.
-
- Disconnect the third row double seat electrical connector.
- If equipped. Disconnect the third row double seat outer seatbelt buckle electrical connector.
- Remove the third row double seat.
- Remove the bolts.
Torque: 52 lb.ft (70 Nm)
- Remove the bolts.
Torque: 35 lb.ft (47 Nm)
- Pull the third row double seat outer seatbelt buckle through the seat cushion.
Third row single seat
- Remove the bolts.
- Remove the third row single seat front bolts.
- Remove the bolt covers.
- Remove the bolts.
Torque: 35 lb.ft (47 Nm)
- Remove the third row single seat.
- Disconnect the electrical connector.
- Remove the bolts.
Torque: 52 lb.ft (70 Nm)
- Remove the bolts.
Torque: 35 lb.ft (47 Nm)