Rearview Camera -R189-, CALIBRATING: Notes

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Calibration Tool :VAS6350A

-- Establish the requirements. Refer to Calibration Tool .

-- Connect the Vehicle Diagnostic Tester.

:VAS6350/1 Installing

-- Check the dimension of the holes.

-- Equip the :VAS6350/1 appropriately. Use spacer pieces. For rims with a large offset (RS 6) use the :VAS6350/5 .

-- To do so, secure the three wheel bolt adapters in the hole circle to each :VAS6350/1 .

-- Place the paddle on both :VAS6350/1 and secure them using a clamping screw.

-- Place the :VAS6350/1 onto the wheel bolts on the rear wheels.

The :VAS6350/1 are positioned by the "O-rings" in the adapters and secured.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Attach the :VAS6350/1 onto the wheels so that any installed "anti-theft" wheel bolts are not connected to the :VAS6350/1 .

-- Adjust the paddles with the aid of clamping screw so that they move freely just above the floor. Check the paddles for ease of movement.

-- Install and align the :VAS6350A . Refer to Calibration Tool .