Calibration Tool, INSTALLING AND ALIGNING: Notes
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Calibration Tool :VAS6350A
- Vehicle Diagnostic Tester
- Calibration Tool - R8 Wheel Adapters :VAS6350/5 for rims with a large offset, for example the Audi RS 6
After performing repair work on the vehicle, it may be necessary to re-calibrate the rearview camera system. In detail, this is the case after:
- Rearview Camera -R189- Removal and Installation
- Replacing the Rearview Camera System Control Module -J772- ; only for vehicles with Rearview Camera System Control Module -J772-
- Collision repairs on rear lid
- Changes to the axle alignment on the rear axle
Calibration Requirements
- The camera lens must be clean.
- The vehicle must be standing on a firm and level surface.
- There must be sufficient open space around the vehicle.
- The parking brake must be set.
- The steering wheel must be in the 0 position and the wheels must be straight.
- All doors and the rear lid must be closed.
- No one should be in the vehicle.
- The vehicle must not be loaded (curb weight).
- Connect the battery charger.
- Before each calibration: turn on the ignition.
The :VAS6350A consists of the following parts:
- Calibration Tool - Wheel Center Mountings :VAS6350/1
- Calibration Tool - Spacing Laser :VAS6350/2
- Calibration Tool - Linear Laser :VAS6350/3