LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Volkswagen >> 2017 >> e-Golf SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 113 (Lighting System) >> Headlight Assembly >> Disassembly >> Hid Headlight Ballast
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Hid Headlight Ballast

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Because the headlight system uses high voltage, be careful not to perform work with wet hands. There is a possibility of electrical shock.
CAUTION:
  • The HID headlight uses very high voltages for the lighting circuit. Make sure that the power is turned OFF before working.
  • Do not leave the headlight without a ballast and back cover for a long time. Dust, moisture, etc. entering the headlight may affect its performance.
  1. Disconnect the ground cable from battery.
  2. Remove the headlight assembly. < Ref. to REMOVAL , Headlight Assembly. >
  3. Remove the back cover.
    Fig 1: Removing Back Cover
    G07672959Courtesy of SUBARU OF AMERICA, INC.
  4. Disconnect the bulb connector.
    Fig 2: Disconnecting Bulb Connector
    G07672960Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the harness connector and screws to pull out the ballast.
    Fig 3: Ballast Harness Connector And Screws
    G07672961Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the harness connector and screws on the back to remove the headlight ballast.
    Fig 4: Headlight Ballast Harness Connector And Screws
    G07672962Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals