Front Crossmember Support Plate: Installation
WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
Install each part in the reverse order of removal.
NOTE:
Tighten the small type crossmember support plate together with stabilizer bracket.
After attaching the stabilizer bracket to the cross-member, tighten the crossmember support plate together with the bracket.
After attaching the stabilizer bracket to the cross-member, tighten the crossmember support plate together with the bracket.
Tightening torque:
Crossmember support plate:
60 N.m (6.12 kgf-m, 44.3 ft-lb)
Crossmember support plate (sections tightened together with the stabilizer bracket):
25 N.m (2.55 kgf-m, 18.4 ft-lb)
Jack-up plate:
60 N.m (6.12 kgf-m, 44.3 ft-lb)