Touchscreen Calibration
WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Calibrate the touchscreen by following the diagnostic scan tool prompts, or the steps below.
- 1.
Make sure the vehicle battery is fully charged in order to avoid an inoperative FDIM touchscreen.
- 2.
Press the FCIM audio power button to turn the audio system on.
- 3.
Operate the audio system in AM/FM mode.
- 4.
Press and hold the EJECT button, and within 1 second, press and hold the SEEK UP button until the speaker walk-around test begins.
- 5.
Press and hold the SEEK DOWN button to enter the touchscreen calibration.
- 6.
Touch and hold the touch points as they appear on the FDIM (a stylus is not required).
- 7.
When the "New calibration settings have been measured. Press the Enter key to accept the new settings." message is displayed on the FDIM, touch anywhere on the touchscreen to accept the new settings.
- 8.
Clear all CMDTCs.