Crankshaft Position (CKP) Sensor: Installation

WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

1.
- 1.
  
  Connect the electrical connector then install the CKP sensor.
- 2.
  
  Install the bolt, tighten to 10 Nm (89 lb-in).

Courtesy of FORD MOTOR COMPANY

2.

Position back the CKP sensor access plug.

Courtesy of FORD MOTOR COMPANY

3.

Install the heat shield and retainers.
- Tighten to 10 Nm (89 lb-in).

Courtesy of FORD MOTOR COMPANY

4.

Install the LH turbocharger. Refer to Fuel Charging and Controls - Turbocharger, 3.5L GTDI .

5.

Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.