10.3 Front Sensor, Removing And Installing
Removing
- Turn off the ignition and all electrical equipment.
- Remove the ignition key, if equipped.
- Loosen the front section of the wheel housing liner, do not remove the wheel housing liner completely. Refer to Body Exterior (Wheel Housing Liner; Front Wheel Housing Liner, Removing and Installing).
- Press both catches in the direction of the -arrow A- and at the same time press sensor -1- inward from outside.
- Release and disconnect the connector -2-.
Installing
Install in reverse order of removal and note the following:
CAUTION:
An incorrect or damaged decoupling ring can lead to malfunctions.
Do not stretch the decoupling ring.
Replace any damaged decoupling rings and be sure the correct decoupling ring is installed.
Do not stretch the decoupling ring.
Replace any damaged decoupling rings and be sure the correct decoupling ring is installed.
- Check the sensor decoupling ring -3- for damage and replace if necessary.
NOTE:
Both sensor mount retaining clips must engage audibly when installing the sensor.