13.4.1 Preparing For Calibration

Conditions 

Under the following condition the Blind Spot Detection must be calibrated:

• The Blind Spot Detection Control Module - J1086- and/or Blind Spot Detection Control Module 2 - J1087- were replaced.
• The Blind Spot Detection Control Module - J1086- and/or Blind Spot Detection Control Module 2 - J1087- were removed and installed.
• The installation position of a Blind Spot Detection Control Module - J1086- and/or Blind Spot Detection Control Module 2 - J1087- was changed.
• The rear bumper cover was removed and installed.
• Corresponding results stored in the DTC memory from the Blind Spot Detection Control Module - J1086- and/or Blind Spot Detection Control Module 2 - J1087-. Refer to Vehicle Diagnostic Tester.

1. Volkswagen Logo
   • The laser pointer is aligned on the center of the Volkswagen logo
2. Calibration Tool - Wheel Center Mountings - VAS6350/1-
   • With 17 mm wheel bolt adapter and measure paddle
3. Calibration Tool - Lane Change Calibration Tool - VAS6350/4-
   • Is moved from the left to the right side of measuring field during calibration
   • When installed correctly, the vehicle electrical system voltage line must be connected at lower left of the calibration device (as seen in direction of travel)
   • Height of the upper edge of the calibration device to the floor: 606 mm
4. Calibration Tool - VAS6350A-
5. Calibration Tool - Linear Laser - VAS6350/3-
   • With "laser protective eyewear"
   • On the -VAS6350A-
   • Turning on and off. Refer to the Operating Instructions.
6. Plastic Foot
   • Can be adjusted when setting the horizontal position of the -VAS6350A-
   • Quantity: 3
7. -VAS6350/2-
   • For distance measurement
   • Usage information. Refer to the Operating Instructions.
8. Measuring Scale
   • For positioning the -VAS6350/4-
   • Dimension to be adjusted measuring point on steel ruler 621 mm
9. Level
   • On the -VAS6350A-
   • To check the horizontal position of the -VAS6350A-
10. Catch Bracket
    • To mount the -VAS6350/2- for the distance measurement
    • Distance to the -VAS6350/1- on the rear wheels: dimension -a- = 1700 ± 2 mm