Test Procedure

Step	Procedure	Result / Action to Take
1	PERFORM: Preliminary Check to verify the customers complaint. Refer to PRELIMINARY CHECK . -- Was Complaint verified?	YES: GO TO Step 2. NO: GATHER more information from customer about the complaint.
2	Remove the DSG Transmission Mechatronic -J743-. Refer to appropriate repair information. Disconnect the DSG Transmission Mechatronic -J743- harness connector. Check the harness connector for damage, corrosion, loose, or broken terminals. Repair as necessary. -- Do any DTC's return:	YES: GO TO: Step 3. NO: GO TO: Step 5.
3	The Engine Control Module -J623- must remain connected for the following step. The central terminal resistor is located in the Engine Control Module -J623-. Using a multimeter, check the DSG Transmission Mechatronic -J743- harness connector T20e / 10 to T20e / 15 for resistance. Specified value: 60 to 72 Ω (at approx. 20° C). -- Was Value obtained?	YES: GO TO: Step 4. NO: CHECK: Wiring for open, high resistance, short or harness connector for damage, corrosion, loose or broken terminals. REPAIR: Faulty wiring or connector. GO TO: Step 5.
4	REMOVE: Engine Control Module - J623-. Refer to appropriate repair information. Using a multimeter, check the CAN bus circuit between T52 / 46 of the Transmission Control Module -J217- and T94 / 68 of the Engine Control Module -J623- for resistance. Using a multimeter, check the CAN bus circuit between T52 / 34 of the Transmission Control Module -J217- and T94 / 67 of the Engine Control Module -J623- for resistance. SPECIFIED VALUE: 0.5 Ω (± 0.3 Ω). -- Were Values obtained?	YES: Remove the Engine Control Module -J623-. Refer to the appropriate repair information. Check each CAN circuit for a short to ground, short to voltage, open circuit or high resistance. If no malfunction is found in the wiring: Replace the DSG Transmission Mechatronic -J743-. Refer to the appropriate repair information. GO TO: Step 5. NO: If the specified resistance value was not obtained and no malfunction is found in the wiring: Replace the Engine Control Module -J623-. Refer to the appropriate repair information. GO TO: Step 5.
5	Final Procedure Perform a road test to verify repair. Do any DTC's return:	YES: Check the DTC memory. Refer to DIAGNOSTIC MODE 03 - READ DTC MEMORY . Perform the diagnostic procedure for that DTC. NO: Repair is complete. Generate readiness code. Refer to READINESS CODE . Return vehicle to Customer.