Service Test, Performing
The printed test results can differ depending on the software version.
Read the Battery Tester:VAS6161 Operating Instructions.
Do not check or charge batteries that have a visual indicator that is bright yellow. Jump starting must not be used!
There is a risk of explosion during testing, charging or jump starting.
These batteries must be replaced.
-- Select "Service Test".
-- Select "at the battery pole" or "at the battery jump start terminal".
-- Select the type of battery: "standard", "AGM", "2*6V" or "Gel".
-- Select the "CCA", "JIS", "DIN", "SAE", "IEC" or "EN".
-- Select battery value.
-- Measure the temperature. Hold the temperature sensor approximately 5 cm above the battery pole until the temperature is stable.
-- Start the test.
-- Print out the test report if necessary.