Selector Mechanism, Disassembling And Assembling: Disassembling

-- Remove the gearshift mechanism. Refer to SELECTOR MECHANISM, REMOVING AND INSTALLING .

-- Bend up the tabs -arrows- on the shift mechanism base plate using a screwdriver and remove the base plate. Only the straps on the left side of the base plate are shown in the illustration.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the seal from the shift housing.

-- Remove the shift cable and the selector cable from the shift housing. Refer to OVERVIEW - OPERATING CABLES .

-- Lift the upper end -A- of the pressure spring over the tab on the selector bracket.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Using a screwdriver, press bearing shell notches -arrows- in direction of shift lever guide bearing; break of notches if necessary.

-- Pry out bearing shell -A- with shift lever guide -B- from selector housing.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Then press bearing shell off shift lever guide bearing and remove.

• Pay attention to the guides -A- in the next work procedure.

  Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

• The guides must not break off.

-- Lift the bottom end -arrow 1- of the pressure spring onto shoulder on selector bracket.

-- Now raise shift lever guide up as far as stop and remove ball studs from selector bracket -arrow 2-.

-- Turn the shift lever guide in direction of -arrow 1-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

• The pins -arrow 2- must be in the shift housing opening.

-- Move the gearshift lever guide and the gearshift lever in the direction of -arrow 3-.