General Repair Information
- Clean the work area and tools before working on the injection system.
- If the high pressure lines are not going to be replaced, they must be marked when being removed. The high pressure lines may only be installed again on the same cylinder.
- Align the high pressure lines without tension. First tighten all connections hand-tight and then tighten them again to the tightening specification.
- Never bend the high pressure lines.
- It is permitted to use tools only for tightening and loosening the lines on the entire high pressure system. All other installation or removal procedures must be performed by hand without using any tools.
- All cable ties that are loosened or cut open during removal must be replaced in the same position during installation.
- Fuel hoses in the engine compartment may only be secured with spring clamps. The use of clamps or screw-type clamps is not permitted.