Selector Lever Handle, Removing And Installing: Installing

Install In Reverse Order Of Removal.Note The Following:

The selector lever is in the "D" position.

NOTE:

It is possible that the button could be pressed into the handle. Never install the handle when the button is pressed in.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Move the button into the installation position. Refer to BUTTON IN HANDLE, MOVING INTO INSTALLATION POSITION .

A new handle is delivered with an assembly fastener. Pull out the safety catch in the direction of -arrow- just before installing the new knob.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the handle with a new clamp -arrow-. Do not clamp the clamps yet.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Press the button after installation.

NOTE:

If the button stays in the handle after being pressed, this means it was installed incorrectly. If this happens, remove the handle again and move the button in the installation position again. Refer to BUTTON IN HANDLE, MOVING INTO INSTALLATION POSITION . Install the handle again.

-- If the button after being pressed returns to its starting position, the clamp can be clamped off using :VAG1275 .

-- Connect the connector.

-- Clip on the cover.