LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Volkswagen >> 2017 >> Golf R Standard Trans >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Assembly >> 10 Engine Assembly >> SUBFRAME Mount >> Transmission Mount, Removing And Installing >> Installing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Transmission Mount, Removing And Installing: Installing

Install in reverse order of removal and note the following:

NOTE:

Replace the bolts that were tightened with an additional turn.

-- Secure the transmission support to the longitudinal member.

CAUTION:

Risk of damaging threads in transmission support by inserting bolts at an angle.

  • The transmission support and the transmission mount support arm must be absolutely parallel to each other before installing the bolts. Push the transmission up using a floor jack if necessary.
  • Only remove the :10-222A  when bolts for subframe mount are tightened to tightening specification.

-- Pull the transmission up using the spindle on the engine support bridge until the transmission comes into contact with the transmission mount support arm.

-- Check the adjustment of the subframe mount. Refer to SUBFRAME MOUNT, CHECKING ADJUSTMENT .

-- Remove the :10-222A  from the engine.

scientia non olet · About LEMON Manuals