SUBFRAME Mount, Adjusting: Procedure
-- Remove the battery tray. Refer to BATTERY .
-- Support the engine in the installation position. Refer to ENGINE, SUPPORTING IN INSTALLATION POSITION .
-- Remove and replace the bolts -arrows- for the engine mount one after the other (if this was not already done when the engine was installed).
-- Install the bolts loosely.
-- Slide the engine/transmission assembly with a extractor lever until the following dimensions are set:
- The clearance between the engine support -2- and the engine mount -1- must be -a- = 10 mm.
- The casting edge on the engine support must be parallel to the support arm.
- Dimension -b- = Dimension -b- .
Distance -a- = 10 mm can be checked for example with a corresponding round stock.
-- Tighten the bolts on the engine mount.
-- Remove and replace the bolts -arrows- for the transmission mount one after the other on the (if this was not already done when the engine was installed).
-- Install the bolts loosely.
-- Pay attention that on the transmission side the support arm and the transmission mount remain parallel.
- Dimension -x- = dimension -x- .
-- Tighten the transmission support bolts.