Service Position, Implementing And Resetting: Notes
Special tools and workshop equipment required
- Guide Pins:T10093
- Adapters For Service Position:T10467
- Torque Wrench 1331 5-50Nm:VAG1331
- Torque Wrench 1332 40-200Nm:VAG1332
Moving into Service Position
The lock carrier is a safety related component. For this reason the lock carrier may not be serviced.
Replace the lock carrier if it is damaged.
For vehicles with the Distance Regulation Control Module -J428-, the Distance Regulation Control Module -J428- must be realigned every time the lock carrier is removed and installed or replaced.
Notes and work procedures for the Distance Regulation Control Module -J428-. Refer to appropriate service information. .
Refer to appropriate service information on hybrid vehicles >>GTE<< for notes and procedures regarding the charging socket.
-- Remove the front bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING .
-- Remove the headlamps. Refer to HEADLAMP [For engine(s) CYFB] .
-- Remove the cable from the lid release mounting bracket. Refer to RELEASE CABLE, REMOVING AND INSTALLING .
-- Disengage the washer fluid reservoir filler neck from the support -2-. Refer to WINDSHIELD WASHER SYSTEM .
-- Remove only one bolt -3- from each the left and right longitudinal members.
-- Install the :T10093 instead of the bolts into the holes in the left and right longitudinal member.
-- Remove the remaining bolts -3- from the left and right longitudinal members.
-- The lock carrier with the attachments -1- can be pulled forward approximately 10 cm on the :T10093 . Be careful of the wires on the lock carrier. Disconnect the connectors if necessary.
-- Install the :T10467 (quantity: 2 on each side) on the left and right side between the bumper carrier and the longitudinal member.