Engine, Supporting In Installation Position

Special tools and workshop equipment required

Engine Support Bridge:10-222A
Engine Support Bridge - Engine Support 18:10-222A/18
Engine Support Bridge - Engine Support 29:10-222A/29
Engine Support - Basic Set Square Pipe :T40091/1 and Engine Support - Movable Joint:T40091/3 from the Engine Support - Basic Set:T40091
Engine Support Brackets:T40093/3 and Engine Support Brackets:T40091/3-6 from the Engine Support - Supplement Kit:T40093A
Engine Support Bridge - Special Hook (2 pc.):10-222A/20

Tool Development

-- If the adapter for :10-222A/4 does not have the indicated holes -arrow- shown they must be added.

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Unlock the retaining tab in direction of -arrow- and remove the engine cover mount -1- .

-- Unclip the right mount -1- for the engine cover from the bracket -2- .

-- Place the :10-222A/29 on both sides of the vehicle between the upper wheel housing longitudinal member and the fender bolting plate underneath.

"L" = -1- Adapter is Installed on the Right Side of the Vehicle (Adapter Secured in the Opening on the Fender).

"R" (Not Illustrated), Adapter is Installed on the Left Side of the Vehicle.

The arrow -2- always points in direction of travel.

-- Push the :10-222A/18 and two :T40091/3 on the :10-222A .

-- Tighten the :10-222A on the :10-222A/29 .

-- Remove the upper section of the washer fluid reservoir. Refer to WINDSHIELD WASHER SYSTEM .

-- If equipped, remove the wires from the front area of ridge on both longitudinal members -arrow- . Do not disconnect the wiring harness.

-- Place the :T40093/3-6 on both sides of the longitudinal member the right longitudinal member is shown here).

-- If necessary carefully unclip the A/C system pipe in the front area. Do not disconnect the wiring harness. Refer to REFRIGERANT CIRCUIT .

Lock the :T40093/3-6 with the pin -A- behind the edge of the longitudinal member -arrow- .

-- Install the :T40093/3 .

-- Connect the :T40093/3 over the :T40091/1 with the :10-222A and tension.

-- Engage the :T40093/3 in the engine lifting eye over the :10-222A/20 and if necessary over the :10-222A/12 .

-- Lightly tension the engine/transmission assembly and Extractor via the :T40093/3 .