Overview - Generator
- Generator -C-
- Removing and Installing. Refer to GENERATOR, REMOVING AND INSTALLING .
- Checking. Refer to GENERATOR, CHECKING .
- Ribbed belt pulley, removing and installing. Refer to RIBBED BELT PULLEY, REMOVING AND INSTALLING .
- Voltage Regulator -C1-, Removing and Installing. Refer to VOLTAGE REGULATOR, REMOVING AND INSTALLING .
- Bolt
- Tightening specification: 23 Nm
- Quantity: 2
- Bushing
- Quantity: 2
- Because the clamping force of a tight bushing is too low despite the correct torque, loosen the bushings
- Connector
- Cap
- Nut
- Tightening specification: 20 Nm
- Terminal 30/B+
- Nut
- Tightening specification: 3.2 Nm
- Only on vehicles with a TDI engine
- Wire Clamp
- Only on vehicles with a TDI engine
- Threaded Pin
- Tightening specification: 3.2 Nm