Assembly Mounts, Checking Adjustment: Procedure
WARNING: This page is about a different car, the 2015 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
The Following Dimensions Must Be Attained:
- The distance -a- between the engine support -2- and the engine mount -1- must be 10 mm.
- The casting edge on the engine support must be parallel to the engine mount support arm
NOTE:
Distance -a- = 10 mm can also be checked with corresponding round stock.
-- If the distance measured is too small or too large, adjust the subframe. Refer to ASSEMBLY MOUNTS, ADJUSTING .