Ignition System Overview
WARNING: This page is about a different car, the 2016 Volkswagen CC, 2015 Volkswagen CC, 2014 Volkswagen CC, 2013 Volkswagen CC, and 2012 Volkswagen CC. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The engine speed sensor is located on the cylinder block. See -item 10- in the COMPONENT LOCATION OVERVIEW - FUEL INJECTION SYSTEM Part 1.
- Ignition Coil with Power Output Stage -N70, N127, N291, N292, N323, N324-
- Removing and installing, refer to IGNITION COILS WITH POWER OUTPUT STAGES .
- Connector
- Black
- Use the Assembly Tool T10118 to disconnect.
- Bracket
- For the knock sensor 1 connector.
- Bolt
- 20 Nm
- Connector
- Black, 3 pin.
- Connector contacts and sensor contacts are gold plated.
- Knock Sensor 1 - G61-
- Installed location: Exhaust side of the cylinder block.
- Bolt
- 20 Nm
- Tightening specification affects the function of the knock sensor.
- Exhaust Camshaft Adjuster
- Identification: 32A
- With the sensor wheel for the camshaft position sensor 2.
- Removing and installing, refer to CAMSHAFT ADJUSTER .
- Cover
- Connector
- Black, 3 pin
- Connector contacts and sensor contacts are gold plated.
- mark the connector before disconnecting
- Bolt
- 10 Nm
- Camshaft Position Sensor 2 - G163-
- For the exhaust camshaft.
- Connector contacts and sensor contacts are gold plated.
- Seal
- Always replace.
- Camshaft Position Sensor - G40-
- For the intake camshaft
- Connector contacts and sensor contacts are gold plated.
- Gold plated sensor contacts and connector contacts
- Knock Sensor 2 - G66-
- Installed location: Intake side of the cylinder block.
- Connector contacts and sensor contacts are gold plated.
- Connector
- Black, 2 pin
- Connector contacts and sensor contacts are gold plated.
- Intake Camshaft Adjuster
- Identification: 24E
- With the sensor wheel for the camshaft position sensor.
- Removing and installing, refer to CAMSHAFT ADJUSTER .
- Spark Plug
- 18 Nm
- Remove and install using the spark plug removal tool 3122 B.
- Type and electrode ga, refer to TEST DATA AND SPARK PLUGS .
- Control Housing
- For the camshaft adjustment.