Battery Transport Mode, Deactivating
The battery transport mode ensures that the vehicle will start.
The battery transport mode reduces the discharge of the battery by switching off any electrical equipment.
All vehicle functions that are not necessary while the vehicle is being transported or that require any power from the battery are switched off when battery transport mode is activated to conserve the battery charge.
This applies especially to all vehicle functions that could be left on and drain the battery capacity.
Examples would be the radio or electronically-controlled doors and attachments, as well as the anti-theft alarm system which could be set off inadvertently during transport.
Procedure:
If the displays indicated in the procedure are not shown on the display. Refer to the Vehicle Diagnostic Tester Operating Instructions.
| ODIS Service |
|---|
| -- Connect the Vehicle Diagnostic Tester. Refer to Vehicle Diagnostic Tester . |
| -- Switch on the ignition. |
| -- Perform the vehicle identification. |
| -- Enter the order data or select "no order". |
| -- Select "control module". |
| -- Select "Data Bus On Board Diagnostic Interface". |
| -- Select "Guided Functions". |
| -- Select "switch on/switch off transport mode". |
| -- Follow the "Guided Functions" instructions. |
Procedure for Fault Stored in the DTC Memory "Vehicle Transport Mode Active P169A00"
-- Switch transport mode on again.
-- Turn off the ignition for ten seconds.
-- Switch transport mode off again.
-- Turn off the ignition again for ten seconds.
The fault stored in the DTC memory "Vehicle transport mode active P169A00" is no longer equipped after performing this procedure.
Keep the Vehicle Diagnostic Tester connected because it may be needed later to perform other checks or tests.