Lower Control Arm, Removing And Installing, Basic: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal. Note the following:
-- Insert the rear control arm into the subframe in the direction of -arrow- and swivel it forward.
-- Tighten the screws -arrows-.
NOTE:
The rear bolt must be attached with a new nut. Counterhold the nut when tightening.
Tighten the bolts -arrows- and nuts in curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .
-- Tighten nuts -arrows-.
NOTE:
Tighten the nuts -arrows- in curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .
-- Install the front wheel and tighten. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .
Tightening Specifications
- Refer to OVERVIEW - SUBFRAME
- Refer to OVERVIEW - LOWER CONTROL ARM AND BALL JOINT