Left/Right Rear Bass Speaker -R15- / -R17-, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
-- Switch off the ignition and all electrical equipment and remove the ignition key.
-- Remove the side trim panel. Refer to SIDE TRIM PANEL, REMOVING AND INSTALLING .
-- Release and disconnect the connector -arrows-.
-- Drill out the pop rivets -arrows- using a : VAS5134 and a suitable spiral bit.
-- Remove the Left Rear Bass Speaker -R15- -1- from the bracket.
CAUTION:
Always remove any shavings resulting from the drilling from the door, otherwise they may cause corrosion damage later.
If the paint on the door frame gets damaged during drilling, touch-up immediately.