MULTIFUNCTION Transmission Range Switch, Adjusting

Special tools and workshop equipment required

Gauge - Multi Function Switch: T10173

-- Move the selector lever into "N".

-- Do not bend the selector lever cable.

Adjustment Requirements:

Selector lever cable is removed from the lever/selector shaft
The selector shaft is in "N".
The bolts on the Multifunction Transmission Range Switch -F125- are loosened.
The lever/selector shaft is removed.

Adjusting

-- Place the : T10173 on the selector shaft -2- and turn the Multifunction Transmission Range Switch -F125- -1- until the : T10173 locks onto the connector tab on the Multifunction Transmission Range Switch -F125-.

Fig 1: Adjustment Tool Attached Onto Shift Rod

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

If the connector tab cannot engage into the : T10173 groove, then the transmission is no longer in "N". If this is the case, shift the transmission into "N" using the : T10173 .

-- Secure the : T10173 on the selector shaft -2- with the bolt -3-.

-- Tighten the bolts -arrows- to the tightening specification.

-- Remove the : T10173 .

-- Further installation is performed in reverse order of removal. Refer to MULTIFUNCTION TRANSMISSION RANGE SWITCH, REMOVING AND INSTALLING .

Tightening Specifications

Component	Tightening Specification
Multifunction Transmission Range Switch -F125- to transmission housing	6 Nm