Driving School Pedals, Adjusting Activation Timing For Control Equipment Warning Buzzer
NOT APPLICABLE TO e-GOLF
General Information
This is performed at every service procedure.
Additional information in Operating Dual Controls this is located with the vehicle. The owner's manual is part of the dual controls. The owner's manual and the general type approval must always be available in the vehicle.
The procedure for the service work is the same for manual transmission or automatic transmission vehicles.
For defects with the driving school pedals, please contact the Volkswagen dealer center with replacement part requests. Additional information is available on Volkswagen ServiceNet.
Driving School Pedal Components, Greasing. Refer to DRIVING SCHOOL PEDALS, LUBRICATING COMPONENTS .
Checking the for bolt for secure fit. Refer to DRIVING SCHOOL PEDALS, CHECKING FOR SECURE BOLT FIT .
Activation Timing for the Control Equipment Warning Buzzer, Adjusting
The control equipment with buzzer -1- is installed in the front passenger footwell.
The control equipment with buzzer when switched on gives an audio signal when the pedal system in the front passenger footwell is operated.
There are two switches, one for the brake pedal and one for the clutch pedal. The procedure for adjusting the activation timing is the same for both.
To adjust the activation timing the adjustment eccentric can be turned.
-- Turn on the control equipment with buzzer function.
-- Loosen the clamping screw until the adjustment eccentric -3- can be turned.
-- Operate the pedal by hand approximately 2 to 3 cm, measured at pedal operation.
-- Turn the adjustment eccentric -3- until the buzzer contact -1- is freed over the operating vane -2- and the buzzer sounds.
-- Tighten the clamping screw for the adjustment eccentric.
-- Check the gear activation timing again.
Target function: when operating the pedals, the buzzer must sound at a 2 to 3 cm pedal travel. After releasing the pedal the buzzer must turn off.
Tightening Specifications