Level Control System Control Module -J197-, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2015 Audi S8, 2015 Audi A8 Quattro, 2014 Audi S8, 2014 Audi A8 Quattro, and 2013 Audi S8. However, it is still accessible from the selected car via links, so may be relevant.
-- If replacing the control module, select "replace" in "Guided Functions" on the appropriate control module.
Use the Vehicle Diagnostic Tester.
-- Follow the prompts on the screen.
-- Turn off the ignition and remove the key.
-- Remove the rear panel trim panel, refer to LUGGAGE COMPARTMENT REAR PANEL TRIM, REMOVING AND INSTALLING .
-- Remove the Radio -R-, refer to RADIO, REMOVING AND INSTALLING .
-- Push back the tab -arrow- and remove the Level Control System Control Module -J197- -1- upward from the bracket -2-.
-- If required, push the wiring harness slightly to the side.
-- Release and disconnect the connector -arrows- from the Level Control System Control Module -J197- -1-.