Rear Heating, Ventilation and Air Conditioning (RHVAC) Control Module: Removal

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Removal steps in this procedure may contain installation details.

Release the clips and remove the front floor console trim panel. Use the General Equipment: Interior Trim Remover

Courtesy of FORD MOTOR COMPANY
Remove the bolts.

Courtesy of FORD MOTOR COMPANY
Position the floor console armrest.

Courtesy of FORD MOTOR COMPANY
On both sides Release the clips and remove the floor console finish panel. Use the General Equipment: Interior Trim Remover

Courtesy of FORD MOTOR COMPANY
On both sides Release the clips and remove the floor console side trim panel. Use the General Equipment: Interior Trim Remover

Courtesy of FORD MOTOR COMPANY
On both sides Remove the bolts.

Courtesy of FORD MOTOR COMPANY
Release the clips and position the floor console rear trim panel out. Use the General Equipment: Interior Trim Remover

Courtesy of FORD MOTOR COMPANY
Disconnect the electrical connectors and remove the floor console rear trim panel.

Courtesy of FORD MOTOR COMPANY
Remove the screws and the Rear HVAC Control Module.

Courtesy of FORD MOTOR COMPANY