LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Volkswagen >> 2016 >> e-Golf SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 124 (Engine Controls (Diagnostics) (H4DO)) >> Subaru Select Monitor >> Operation >> How To Use SUBARU Select Monitor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

How To Use SUBARU Select Monitor

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Prepare the Subaru Select Monitor kit. < refer to PREPARATION TOOL , General Description >
    Fig 1: Identifying Subaru Select Monitor Kit
    G07670213Courtesy of SUBARU OF AMERICA, INC.
  2. Prepare PC with Subaru Select Monitor installed.
  3. Connect the USB cable to SDI (Subaru Diagnosis Interface) and USB port on the personal computer (dedicated port for the Subaru Select Monitor).
    NOTE: The dedicated port for the Subaru Select Monitor means the USB port which was used to install the Subaru Select Monitor.
  4. Connect the diagnosis cable to SDI.
  5. Connect SDI to data link connector located in the lower portion of the instrument panel (on the driver's side).
    CAUTION: Do not connect the scan tools except for Subaru Select Monitor and general scan tool.
    Fig 2: Locating Data Link Connector
    G07670214Courtesy of SUBARU OF AMERICA, INC.
  6. Start the PC.
  7. Turn the ignition switch to ON (engine OFF) and run the "PC application for Subaru Select Monitor".
  8. Call up DTC and data, then record them.
    NOTE: For detailed operation procedures, refer to application help for Subaru Select Monitor.
scientia non olet · About LEMON Manuals